The photo below may seem an unlikely choice on tugster, especially as lead photo. I post it here because this is where Urger in 1901 was designed, built, and launched at 300 Pine, on a finger of the Grand River and not far from Dornbos Island. I mention that because Urger was initially called Henry J. Dornbos.
Another odd photo lies below, until you recall some posts almost two years ago . . . Mariners to Muskegon. Here behind the chainlink, Colleen and Katie G await matched barges.
Trieste used to be called Vegsund.
I was fooled here: although the stern looked bald, I thought it was a laker
but wondered why the bridge windows were covered.
I was making no sense of the lines near the stern, until I remembered that this “laker” was a barge. No stack existed because the power plant was removed and turned into a notch. Her matched tug is Invincible; see them paired in this post (and scroll).
Sarah-B is a 1953 Roamer built tug, that went from USACE to a museum and back into service.
Is this a one-off?
And finally, I took a tour of this 1904 car ferry, now called Milwaukee Clipper, named like the PanAm flying boats.
For the first decades of her existence, the Clipper was SS Juniata.
All photos by Will Van Dorp, who needed to get back on the boat and continue the loop.
2 comments
Comments feed for this article
August 28, 2018 at 12:27 pm
Bill Hook
Do you have any information about the counterbalance ramp where the Milwaukee Clipper was moored. Interesting shapes but seemed to be missing some of the mechanisms to activate them??
August 28, 2018 at 6:27 pm
bklynphil
A lot of historic info and pictures –
https://tinyurl.com/y8jlkz9c
full url
http://www.picsearch.com/imageDetail.cgi?id=Pd49UjDaUyk8xMHX0XalWpn4zk7dbW9FZkBvGSMxzkA&start=1&q=The%20Manitowoc%20Company
Phil, Bklyn